Transmission Code P0705 A Comprehensive Diagnostic Journey

It started fine, drove fine, there was a code for the transmission range switch, but it wasn't definitive (or something like that). The transmission range sensor is in the Gear shifter module. Pull the old one and get the exact part #. I put my part # in an ebay search and i ... P0705 shows that a Transmission Range Sensor (TRS) input error has been obtained by the Engine Control Module (ECM) or Transmission Control Module (TCM). These DTCs indicate a problem with the park/neutral position switch and the wire harness in the park/neutral position switch circuit.For ... Go to start car and it briefly shows P but then PRND321 gets black bar across entire length of display. Car starts correctly and only starts in P and N. I have a code P0705, Trans Range Sensor Circuit Malfunction. (PRNDL input) Symptoms are: A few seconds after startup, a squeak coming from under and around ... It's either the sensor or some damage/corrosion in the wiring to the sensor. A bit of electrical diagnosis can determine which one. If it starts ... P0705 indicates an inhibitor switch issue (part no. UHB500020) http://www.rangerovers.net/forum/6-range-rover-mark-iii-l322/23342-misc-transmission-errors- ... My 2013 has started doing this. But with the recent very cold weather, I get the CEL, 4LO etc etc , I check and then delete the code, it's good for a week, ... Error code P0705 is the result of a failure in the circuit. Your powertrain control module either doesn't recognize the signal or is receiving no signal at all.