Demystifying Transmission Code P0705 A Detailed Analysis

When the code P0705 is set in the Powertrain Computer, it means that the Powertrain Computer or PCM is not seeing a clear, rational change in the data and ... The transmissions gear selector cable might be binding somewhere or the NSS may even be loose on the transmission. You'll have to check it. OBD2 ... it gave me the code "p0705 transmission range sensor malfuction (prnd) input" so i went ahead and replace the park/ nuetral switch, and it ... Usually its water intrusion in the wiring harness but the switch can go bad too and it usually leads to falling out of overdrive while cruising ... P0705: - Transaxle Range (select lever) switch indicates an illegal position - PCM detects an illegal range for 10 seconds. The tsb states that if liquid or corrosion is observed, then the wire harness should be replaced. The dealership did not even ck this on their own. P0705 indicates an inhibitor switch issue (part no. UHB500020) http://www.rangerovers.net/forum/6-range-rover-mark-iii-l322/23342-misc-transmission-errors- ... It is caused by poor connection on the 3 connectors that come off of the gear box/tranny. I have tried to di-electric grease them, tried crimping them tighter. The P0705 code uses a '2-trip' detection logic, so the fault condition must be present for 2 consecutive driving cycles before the CEL will be ... It's either the sensor or some damage/corrosion in the wiring to the sensor. A bit of electrical diagnosis can determine which one. If it starts ...