Key Not Releasing from Ignition Switch Identify and Overcome Obstacles

A shot of oil in the lock cylinder may help. DO NOT USE GRAPHITE! Use a light oil, such as wd40, pBlaster, Houdini, etc. But yes, if the ... ... would not start and the key would not come out of the ignition. Battery was fine and all the dash lights were normal - just would not start. Step 1: Make Sure You're in Park · Step 2: Try a gentle, but deliberate, motion in jiggling the key · Step 3: Check for buttons near the ignition · Step 4: Try a ... Usually this is caused by failing ignition lock cylinder, listen for key in ignition chime with key removed, try tapping on cylinder and see if chime stops. If ... Try a little light percussive maintenance on it but not hard enough to break anything. Usually if the car is not in park it won't turn all the ... The key won't engage the pins in the ignition cylinder if it's filthy. If you used your key to open a package recently, for instance, there may be bits of tape ... Pushing the button with the paperclip and at the same time turn the key counter Clock wise, this will release the key and you can pull it out ... The lock cylinder itself could be bad. I see it much more commonly on GM products, but the key can get stuck in the ignition, and no matter what ... It's probably a electromagnet or a spring that winds when the key is turned. I've never seen one go bad but there's a first time for everything. If you have not had the ignition lock recall done then its likely the tumblers in the lock have failed and you will need to have it hauled to ...