Discover the Power of p0123 The Ultimate Guide

If you got coolant on the sensor that may have tripped the light for a little bit. It happened to me when I changed my turbo with my TGV sensors ... VRSC Models - Help, Code P0123 - Bike is dying on me, ran the diagnostic & cleared code P0123, but still not running right! P0123 (M) Throttle Position Sensor Voltage High Throttle position sensor input above the maximum acceptable voltage. I got the code P0123 so I figured I'd check the Tps sensor voltage and it was reading fine (has power, signal, ground) also checked it with throttle open and ... The P0123 code means the PCM sees the voltage as too high in the TPS circuitry. The TPS uses the 5 volt reference circuit to provide it's signal to the PCM. I get these error codes P0123, P0223- which involve the drive By wire pedal sensor And high circuit voltage. is thus a wiring issue I should be checking before ... I hear this is an electrical issue but the voltage to the TPS is 4.95v and the ground is solid against the battery at 12.35v. Code P0123 may be triggered when your car computer receives a signal from the TP sensor that exceeds the maximum limit for a set period. The reference voltage should be 5V. The reading at idle should be .6V. The WOT reading should be above 4.0V, but when it goes above 4.75V, the DTC gets set. The voltage for the TPS with it disconnected to be over 4.47 volts. If it is that high, the PCM will not pulse the injectors. Could be something as easy as a ...