Experience Dynamic Audio Tweeter for 4-Ohm Speakers

Two 4-ohm subs wired in parallel will give you a 2-ohm load. Your amp instructions should address tri-mode wiring, a.k.a "mixed stereo-mono." Assuming your speaker doesn't use a ribbon tweeter, and you follow ... I can't speak for early Nait 1 e 2 that were tuned with period loudspeakers ... Have two 4-ohm car stereo tweeters. Foolish to try to use (w/bigger speakers also) in a Bandmaster? ; billy logan · Sep 18, 2019 · 1,919. Depending on the options, some even allow using 4 ohm speakers with an 8 ohm amp and vice versa. They're also really handy when using ... The speakers are 4ohm, and the tweeters are also 4 ohm, which in parallel should make a 2ohm load (not counting wire resistance). In regards ... Sure, you would wire them in series to 4 ohms (nominal).... but; You should really use some kind of passive crossover. If you don't, it's going ... The correct way to do that is to use a two way crossover that both the woofer and tweeter are connected. 3. Compatibility: A 4 ohm tweeter is highly compatible with a wide range of amplifiers and speaker systems. Whether you're using it in a home theater amplifier ... It is not easy to connect three speakers together and keep a 6-8 ohm load to the amplifier. Normally you should use a crossover circuit to connect these ... The “standard” 4-Ohm is not a worse speaker. The desire for a 2-Ohm system allows more power to flow from your head unit, or an amplifier. This ...