Dynamic Tweeter for 2x 4-Ohm Speakers Upgrade Your Soundstage

Most component sets use crossovers to separate the frequencies for each speaker. There are active and passive crossovers. Find a nice set of passive crossovers ... It is not easy to connect three speakers together and keep a 6-8 ohm load to the amplifier. Normally you should use a crossover circuit to connect these ... ... loudspeaker enclosure. Dayton Audio AMT (Air Motion Transformer) tweeters use groundbreaking transducer technology from the original ESS/Heil Air Motion ... A 5.25 inch speaker will not put out much bass as a subwoofer. And a 2 inch tweeter is only going to output a moderate level of midrange sound ( ... If you run the speakers in series, you'll get 8 Ohms, if that helps. With two separate cabinets, that is a little more involved than running ... ... 4ohm impedance speaker ... using the the ones with the speakers. I was not aware that there was a pair included: "These 3-1/2" speakers ... I've been running my subwoofer at 2ohms for however long and Tonight I decided to switched it to 4ohms (running only one of the voice coils) ... If you replace an 8 ohm tweeter with a 4 ohm tweeter the crossover frequency will double for a first order filter such as used in the Six. Basically frequencies being handled by only your tweeter will be 2 ohm and frequencies being handled by your mid will be 4 ohms. Unlikely. For low frequencies (ie below 500 Hz) the tweeter arrangement will have a relatively high impedance and therefore will not affect the net impedance ...