Enhance Your Sound System Tweeter with 2 4-Ohm Speakers for Exceptional Performance

The speakers are 4ohm, and the tweeters are also 4 ohm, which in parallel should make a 2ohm load (not counting wire resistance). In regards ... Two 4-ohm subs wired in parallel will give you a 2-ohm load. Your amp instructions should address tri-mode wiring, a.k.a "mixed stereo-mono." The resistors could be for impedance or protection, and probably specific for the tweeter. Using a preamp's tone control is sometimes better ... 3. Compatibility: A 4 ohm tweeter is highly compatible with a wide range of amplifiers and speaker systems. Whether you're using it in a home theater amplifier ... Yes. 2 4-ohm woofers in series, and an 8-ohm tweeter, would be just fine. What you have to understand is that the resistance you measure with your multimeter ... No. You need to run those speakers thru a passive crossover. At the frequencies sent to the tweeter the amp will see 8 ohms and at frequencies ... 2 A 4 ohm load for the amplifier is PARALLEL CONNECTED to the 8 ohm full sound range. when you add a 4 ohm tweeter to which you put a 3.3 micro ... No. Unless you put in a crossover network? The tweeter will be destroyed in a few minutes of playing. Even just using a simple non polarized ... So, using one of those math formulas, an amplifier that provides 100 watts of power through a 4-ohm speaker, will produce 200 watts through a 2- ... Connecting two 4 Ohm speakers in series, for example, results in an 8-ohm total load. In a parallel connection, the impedance is divided by the ...