My Top Brake Light Remains Illuminated A Troubleshooting Guide

There is a little rubber bumper stopper up near the top of the pedal. If that rubber bumper stopper falls out (an it does eventually fail and ... The cause of this, they said, was that the LED bulbs had an improper resistance level in comparison to the stock incandescent 3157 bulb. Pull the tails and check the bulbs, if they are the correct type make sure they are seated correctly and not burned out, if they are LED's take ... Like others suggested, check the fluid level in the brake fluid reservoir tank. Unless it's already at the "full" mark, top it off, and see if ... This sounds like the ABS control module is back feeding the third brake light here is a wiring diagrams so you can see how it works and a video ... Two possible causes to start with: 1. A short in one of the brake light bulbs between the tail light & brake light filaments. With the parking ... Make sure you check all your fuses and wires. Normally its not the wires or fuses, but you always want to be sure. If you buy the car from ... probably something with the brake light switch on the brake pedal. try pulling up on the brake pedal and if the lights go off, then you can ... I actually searched for where I can find my break light fuse, to turn off the light, instead I found this. This is the real, unerline issue ... Which means that the LED's should all be off if the brake is not applied. Have you made any other modifications in the rear lighting circuit?