Transform Your 2012 Vehicle The Ultimate Guide to Rear Passenger Bearing Hub Replacement

Attach a slide hammer to the lugnuts and give it a couple solid hits to pull the hub out (it's easiest to do this on the car). Name: Picture107. It is a simple job to pull the rear hubs and bearings. Jack it up remove the wheels, remove the drums. Note: There are two threaded holes in the drums. Youll need: new wheel bearing, new axle bolts (they use a special 18mm tripple square DRIVER) do not confuse em with the front, they use a 27mm socket. Honda Accord & Crosstour (2003 - 2012) - Replacing the rear wheel hub bearing?? - I would like to say to my fellow Accord owners! I didn't think that was worth it. You need to press the old part out and press it into the new hub assembly. Don't try to use a hammer to ... The hub and bearing are both pressed in from the outside of the car. There is a ring clasp on the outside of the wheel bearing which I couldn't ... ... 2012 Chevrolet Equinox 2013 Chevrolet Equinox 2014 Chevrolet Equinox 2015 Chevrolet Equinox 2016 Chevrolet Equinox 2017 Chevrolet Equinox ... Step 6: Loosen the hub nut with the special socket (on my truck the Drivers Side was LH Thread, and the Passenger Side was RH Thread; some axles ... You actually replace the entire sealed assembly (wheel hub). If you can replace rotors you can replace the hubs. They are attached with 4 ... Backstory: Both my front wheel bearings were toast at roughly 140,000km, with the passenger side noticeably worse (REALLY LOUD). It had started ...