Transform Your Ride The Ultimate Guide to Rear Passenger Bearing Hub Replacement (2012)

It is a simple job to pull the rear hubs and bearings. Jack it up remove the wheels, remove the drums. Note: There are two threaded holes in the drums. It needs a rear wheel hub assembly. I have it all torn apart. But when looking at replacement bearings i have seen 3 bolt ones and 4 bolt ones. 2325 posts · Joined 2012 ... So I have some fluids being sprayed into the inner side of the rear driver rim and I'm suspecting it's a bad axel ... This video shows you how to install a new wheel hub and bearing on your 2008-2012 Honda Accord. Do not forget to add the new snap ring before pushing the hub back in place. Pushing the hub in will require 5-6t. Pressure must to go only on ... Since you are replacing the part, a slide hammer can be used to remove the hub if it's stubborn. Otherwise, if one were reusing the bearing, the ... Remove the wheel bearing housing off the knuckle. Loosen the four 19 mm bolts enough but not complete off the hub; using a hammer and whack each ... ... 2012 Honda Pilot 2013 Honda Pilot 2014 Honda Pilot 2015 Honda Pilot Tools you will need: • Phillips Head Screwdriver https://trq.video/oaY2 ... The wheel bearing will slide off at this point; replace it with a new one and re-install the nut. You will need to de-stake the nut before ... found a write up for removing front bearings, knuckles have to come off. So for rear with AWD I'm assuming the same. Passenger side saturday, ...