Empower Your Ride A Comprehensive Guide to Rear Passenger Bearing Hub Replacement (2012)

It is a simple job to pull the rear hubs and bearings. Jack it up remove the wheels, remove the drums. Note: There are two threaded holes in the drums. Since you are replacing the part, a slide hammer can be used to remove the hub if it's stubborn. Otherwise, if one were reusing the bearing, the ... ... posted in this video. How to Replace Rear Wheel Bearing & Hub Assembly 2007-2012 Nissan Altima. 18K views · 1 year ago ...more. TRQ. 607K. Loosen the four bolts holding the hub but don't remove them. Leave the axle nut in place and use the slide hammer. Once it breaks free a little ... Do not forget to add the new snap ring before pushing the hub back in place. Pushing the hub in will require 5-6t. Pressure must to go only on ... Does anyone have a parts list for everything needed to replace the rear passenger side wheel bearing on a 2010 prerunner ... Former 2012 DCLB 4x4 ... Youll need: new wheel bearing, new axle bolts (they use a special 18mm tripple square DRIVER) do not confuse em with the front, they use a 27mm socket. you can re use the hub. you could have saved yourself some significant cash. and you didnt remove it properly. you pulled the bearing apart. This video shows you how to install a new wheel hub and bearing on your 2009-2015 Honda Pilot. To get the old hub off, you need to remove the wheel, remove the brake drum, pry off the cap (Part #2), remove the nut (Part #28) and slide the ...