Transformative Alignment A Complete Guide to Indexing Steering U-Joints

I've had to clean the splines on my rack, my column, and my U-Joint. I used a wire brush on the shafts and a sharp awl to clean the splines on the U-joint ... MidnightBurn's specs); it has a Saginaw power steering box- all the hoses are in. I have a 3/4" steering universal joint at the end of the ... The VW U joints are pretty sloppy if you ask me. Not only do the spines only go a short way into the U joint but there's a lot of slop in the ... Ujoints are nonreplaceable and, as noted above, are staked in place. Also, they are preloaded when assembled in the yokes. Without this preload, ... (? not sure proper name). It shouldn't move out of place unless you grab your steering wheel when it is disconnected. I was able to use two tubes ... In this video you can see the bottom u-joint that attaches to the rack and pinion fully articulates no problem, but the top one that connects to ... Most likely will have to take them apart and compare by measureling to Spicer PTO u joints. So strange for them to be loose as they get very little rotation ... Does anyone here know how to remove/replace a u-joint in the steering shaft? I don't know about other areas but here in VT the lower u-joint ... If you google steering phasing, some believe you keep the u-joints in phase others say they have to be out of phase 15-45 degrees... Heavy Metal ... The notchiness is a pretty good sign that the joint is messed up. You would have to disconnect and flex the ends to really isolate it though.