Effortless Indexing A Step-by-Step Guide to Steering U-Joint Alignment

Pull the bolt out of the steering column at the top joint, turn slow and carefully and see if binding stops, and look for up/ down movement of that joint on ... if your sure its straight go for it or you could relocate it to somewhere more convenient. only thing to know is make sure you dont excede the ... If you grab the shaft just above the u joint and you can move the shaft within the u-joint connector I believe you have the same issue that I ... I worked the grease into the joint, by suspending the front, and turning the steering wheel full lock-to-lock, over a dozen times. That way you ... Try rotating them slightly out of phase. Might help although you are running at way more angle than you should. Must joints are good to 30-32 degrees. Easiest way to fix it is with a 12mm socket, about a foot long extension and a ratchet. Just tighten it up a bit, it will take a bit of force. Most likely will have to take them apart and compare by measureling to Spicer PTO u joints. So strange for them to be loose as they get very little rotation ... Working on tighening up the front end of my CJ7, I'm now on the steering shaft. There is a lot of play in the universal joint near the brake ... Pop u-joint/yoke thing on the upper steering rod first, slide it upwards and then get the lower section on the other splined part. I imagine the ... Anyone heard about using one of these on a bike for steering? From the beginning, I've wanted to build a recumbent bike, ...