Universal Joint Replacement Your Gateway to Unrestricted Mobility

Just take off the U-joint using a 7/16 wrench. Slide the drive shaft out off tranny. Remove retainer clips with flat screw driver. Set the drive shaft on the ... That video is pretty much how it's done - using a socket that matched the ujoint diameter a hammer and a big c-clamp. Some will have inner or out clips holding ... The first step in replacing a universal joint is safely readying a truck for maintenance. This means removing keys, chocking wheels and, in this case, raising ... Here is my first how to thread--hope it helps someone. Now, let's replace some u joints! Tools needed-- 12mm 12 point wrench Pliers--I used ... You have to heat the yoke and melt the plastic/nylon out. Then change the joint as normal. When you install the joint you will need to use the supplied clips. I have heard of just replacing the u-joints with success. I would also consider asking them to use hardware with grease fittings, so you can keep it properly ... Never done my frontier yet, but their regular 1310 series joints that can be had anywhere for 15 bucks, time to change varies with experience, a ... Hello, is-it possible to replace only the U-joint ? Do i need to buy the complete driveshaft if my u-joint is worn ? The rear flex coupling failed, so I removed the entire drive shaft to check the rest of the parts; So, has anyone had any success in just replacing the u-joint? I've pushed them out using a vise and sleeve but that's a tough tricky way to do it. Damaging or tweaking the yoke is the big hazard doing it without a press ...