Unmasking the Mystery of Brakes Hitting the Floor A Troubleshooting Adventure

Not true. If you pump the pedal and it becomes firm but then let off and it's soft when you reapply the brakes, that's a classic symptom of air ... If you are positive that there are no leaks (be sure to check all lines, wheel cylinders etc) then the most likely cause will be your master cylinder bypassing ... One of the most common reasons for your brakes touching the floor would be an issue with your brake fluid. Your fluid being low or air reaching ... It's either a burned out bulb, or it fell victim to something in the creative wiring done by the previous owner (discovered more of that ... While you have the booster off and the vac line is disconnected turn it upside down to make sure fluid has not accumulated in it. When you go back together with ... The brake pedal goes to the floor with very little resistance. It isn't spongy like there is air in the lines. It just goes to the floor if you push it all the ... It sounds like you have a failed master cylinder. The fluid is by-passing the piston cups, thus the pedal "fades" to the floor, instead of applying pressure to ... This could indicate an unevenly worn rotor, dirty brake fluid or contamination of the fluid by moisture. You can solve such a problem with a relatively ... This maintenance guide will give you the steps to troubleshoot and fix this issue of the brake pedal going to the floor in under 45 minutes. Air in the system. Make sure you are bleeding them in the proper order and that the reservoir doesn't go empty. If it does you end up with air ...