Brake Pedal Hitting the Floor? Here's the Ultimate Fix

It sounds like you have an internal leak in your brake master cylinder. With steady pressure the brake pedal should not move, if it does then it ... Is your brake pedal sinking all the way to the floor when you press it? Does it feel softer than normal, or spongy? Typically, the three most common problems related to brake pedal sink are caused by the master cylinder, a brake fluid leak, or ABS unit leak. The Master ... The pedal goes basically all the way to the floor on the first pump, when I pump the brakes again the pedal rises, feels very firm and the truck stops well. First thing is check the level of the fluid in the brake reservoir. If low, I'd suspect a leak. Check all the wheels for leaks at the calipers/cylinders. The theory of a dual master cylinder is you'll still have front or rear brakes if the opposite end of the car/truck fails. Usually by the time ... Causes and fixes when a brake pedal sinks suddenly all the way to the floor. Posible Causes Low on Brake Fluid Possible Brake Fluid Leak Air ... The truck wouldn't stop unless you put your foot to the floor. After bleeding all the wheels again, same problem. I found out there is a "fifth" bleeder ... When I push the brake pedal, it goes all the way to the floor on the first push, and then on the second push it goes halfway and the brakes bite properly. If your brake pedal goes to the floor but still stops, you may be using your pads' metal to stop rather than the pads themselves. Do yourself a ...