Restore Your Vehicle's Performance with CV Boot Replacement

... replacement inner and outer clamps that you can try. Have ... If you're going to reboot your CV axles, you should also replace the ... If your vehicle vibrates during acceleration, then you might need a new inner CV joint. The outer joint can cause vibrations too but outer joint ... Jack car and take tyre off, release steak nut locking device (half shaft retaining nut) with screw driver/chisel and pound hammer taking care ... This should help anyone who will only be replacing the driver side outer (or inner) CV boot. This is specifically for the driver side axle. "Split Boot"*: If you haven't encountered one, it's a CV boot that wraps around the axle and is glued together on one side. I've found a " ... It's not hard to do at all. If you are replacing the outer CV boot I highly recommend disassembling the inner CV and sliding both boots off the shaft toward ... Slide steering knuckle off the CV shaft. Remove the heat shield that protects the CV boot (if you don't have a heat shield, that is why you are replacing the ... Once you get the CV joint to the bench, clean it out (Preferrably by taking it apart) , regrease it (press lots of grease way inside where ... My advice would be do the whole axle, when you get the point of where you would just do the boot, you are just a pry bar and hammer hit away from removing the ... I recently did the rear end and noticed that the CV boots need to be changed. Autohaus only has the outer boot kit.