Empower Your Climate Control The Definitive Guide to Blend Doors

The temperature blend door is the device that sends air over the heater when the heat is on and air over the cooler when the air conditioner is on. My HVAC got stuck a couple times with full hot blowing out of the driver's vents and cool air coming out of the passenger vents. The fault is in the control head, not the actuator itself. If it's moving back and forth, grab the knob and push in on it, if it changes the movement of the ... The floor control actuator does not have stripped out gears, it operates just fine in place of any other actuator, and all good actuators, when plugged into ... The blend door actuator is under the dash on the drivers side not far from the gas pedal. Replacing the door means removal of the WHOLE dash and airbox. The new replacement actuator is not fitting correctly into the gears of the Blend Door Actuator, but the Ford Mechanic will be able to help you with this issue. 1 Center Register Air Discharge Temperature Sensor 2 Blower Motor Speed Control 3 Air Inlet Door Actuator 4 Blower Motor 5 Passenger Side Temperature Door ... The right actuators behind the glove box rotates when the temp comes down on the drivers side temp knob, the left actuator doesn't rotate at all. The latest is with the AC blend door on the passenger side. I did the typical resets to get the passenger side actuator to recalibrate and could ... Apparently it is common for the blend door shaft to crack and the actuator will rotate without turning the shaft.