Fine-Tune Your Ride's Temperature The Power of Blend Doors

The blend door actuator(s) are typically located on the climate control case behind the dashboard. Consult a repair manual or repair database ... The floor control actuator does not have stripped out gears, it operates just fine in place of any other actuator, and all good actuators, when plugged into ... The blend door actuator is low power stuff, like door lock actuators. It doesn't have a specific fuse. You can visually check if it works ... The heater blend door actuator is a small electric motor and gear that is connected to the heating and A/C/ system's control module. This then controls the ... I researched online and saw a few places talking about how the actuators needed to be calibrated after installation. That video got the job done for getting it apart. I ended up drilling a 3/8 hole right through the fan enclosure to get a straight shot on that ... You can run a diagnostic self check that will move the blend door all the way open and closed. If it fails to go all the way in each direction, then a fault ... After three months of use my blend door is stuck in the cold position again. This time I not only wiggled it with my hand but also used silicone spray ... when you take out the bad actuator take it apart and you will see some little broken plastic gears. good luck and read over the posts. The new replacement actuator is not fitting correctly into the gears of the Blend Door Actuator, but the Ford Mechanic will be able to help you with this issue.