Unleash the Power of Ammeter Shunts Your Secret Weapon for Diagnosing Parasitic Draw

... parasitic drain (currently showing 0.6amps when van is asleep). I ... You can use a stand alone clamp meter... www.t6forum.com. Clamp ... If I'm seeing it right you have the range set to 200mA but the current flowing through the 10A input (10A shunt). It's not going to hurt ... The primary tool used is a voltmeter. However, they do start by measuring the "sleep mode" current draw at the battery. This can often be done using the ammeter ... The other thing you need to do the draw test properly is the correct values for each systems parasitic draw. I find it a lot easier to watch the meter values ... What I always forget is that I then go and open the car door and the interior lights turn on and depending on the car it can blow the meter fuse ... verses the intermittent ones that just show up for a second and dissapear before you can catch a glimpse of the meter. I am interested as to ... I will describe how to test the parasitic draw. The method I describe uses a resistor connected in series with the battery and a voltmeter to ... ... show 0.000. The multimeter is new and it is set up properly for ... Whenever I check for draw, I normally start by setting the meter to ... This parasitic draw, when it occurs, is so strong, it'll zap the battery overnight and have even seen it suck down to 5-6 volts left on the battery the next ... Lisle sells an inexpensive parasitic draw adapter, with fuses, to use with a meter; it's not a rocket science design, but for the $, it's ...