Revolutionize Your Ride Replace Tie Rod Boot for Unmatched Performance

You need a tool to drive the boot down into its seat on the ball joint. Honda sells a tool to do this, but I made one using PVC pipe. I found a pipe that was a ... That hard line is used to equalize the air as the bellows open/contract on either side. There should NOT be any fluid in it! If there is, you'll ... You can replace just the boot, but it's the same job to just replace the whole axle and a lot less headache. Look for the write up on Audiworld on how to do it. You don't have to take the tie rod end out of the knuckle you can just unthread the tie rod from the tie rod end and since the rack end is a ... My passenger side tie rod boot was ripped not too long ago and I'm wondering if I should replace the boot or the entire rack. They work perfectly on the ball joints though, as they slip over the entire joint and slide up against the upper control arm. My balls were in ... It is possible to replace just the boot. All you have to do is take the tie rod end off and slip on a new boot full of grease, then clamp it down. unless you just happen to have it available... Quite sure the RH boot on mine is original and is as good as new still after 200k km. Both my tie ... Your suggestion to replace just the boots is a good one, but I don't think I have enough finesse as a mechanic to do it, nor do I have the ... I was a Service Manager for and Acura dealership. Also an ASE master tech. Put the boot in hot water for a few minutes. This will soften the ...