Experience the Difference Tie Rod Boot Replacement Enhanced

Mark the lock nut location with paint or a file. Back the nut off and separate the inner and outer rods, remove the lock nut. Replace the boot. It is okay, but you are getting dirt in the joint but should not cause a problem for some time, probably would not want to run it past next winter. It is possible to replace just the boot. All you have to do is take the tie rod end off and slip on a new boot full of grease, then clamp it down. You definitely don't want to leave the tie rod with the broken boot. It will get contamination in there and fail much faster. At this point, you ... sounds like you're done and moving on with mechanic but they can be changed without a jack and without removing both tie rods. if it's an ... If there's no play in the joint itself I wouldn't worry about it right now. It's just a dust boot. Really some inner rods are a pain and then ... Yes you can buy just the boots. I would replace it with a tie rod from a V8 ZJ. I spent $20 on mine from a junk yard and have beat it pretty ... Buy Now! New Steering Rack & Pinion Bellow from 1AAuto.com https://trq.video/ia-1ASFK08345 New Steering Rack & Pinion Bellow from 1AAuto.com ... They work perfectly on the ball joints though, as they slip over the entire joint and slide up against the upper control arm. My balls were in ... Really needed to replace two neglected tie rod boots on my 1995 Wrangler YJ. Replaced them with new polyurethane ones purchased from Simpson ...