Empower Your Ride Replace Tie Rod Boots for Enhanced Steering

That hard line is used to equalize the air as the bellows open/contract on either side. There should NOT be any fluid in it! If there is, you'll ... May take a wack or two but it will let go. Then finish unscrewing the nut, slip the boot on and re-tighten. Done and done. Tie rods are one of ... You need a tool to drive the boot down into its seat on the ball joint. Honda sells a tool to do this, but I made one using PVC pipe. I found a pipe that was a ... The boot over your inner tie rod aka steering rack bellows protects your steering linkage from dust and grime. It is important to replace ... Or just reuse your old boots in good condition, check on them more often and replace them when they fail. If you don't ever check those boots or ... Do you have a torn boot or are they leaking? If it's torn, replace it. If it's leaking, you need a power steering rack. Those boots aren't ... The procedure is all most the same for all the cars. The only not common tool You will need is the Ball Joint separator. When You replace ... Those are just dust boots, they don't hold any fluid or grease. If you're still just going to replace the boots, you just take the nut off the ... Autozone "HELP!" section has some generic boots that may work. Or you could get the tie rod exchanged as Moog has a lifetime warranty on them. My passenger side tie rod boot was ripped not too long ago and I'm wondering if I should replace the boot or the entire rack.