Tackle Stripped Lug Nuts Head-On A Comprehensive Guide to Removal

The easiest way to remove a wheel stud is to tap it out with a hammer (tap, not pound it out). If the stud is to be reused then put a lug nut on. Where you are stuck, just grind a flat spot on the stud to start drilling away the stud. 1Hour and the job will be done... Start with good ... I had a lug nut break once and it wasnt able to be removed from the lug. To remove it I just drilled it out with a 1/2 inch drill bit. You ... So we'll just start hitting it. And then it goes. Now in this case, there's not enough room for the stud to go through. So here's a trick. Get a ... Electric or pneumatic impact wrench with a quality, correct sized socket. If you have to hammer the socket to get it in and seated completely on the nut then do ... Went to put on some locking lugnuts and one of the lug nuts froze on the threads and the wheel stud started to free spin. I took a die grinder ... Worst case you can always grind the head off the back of the stud and punch it through if you truly can't get it off. You"ll need a lift though. Just drill the center of the stud out from the nut side. I personally drill a pilot hole and then grap a drill bit a little bigger than the stud ... Find a socket slightly smaller than what's on the car. Hammer the smaller socket on to the lug nut then use a breaker bar to take it off. if not any auto parts store should sell striped nut remover kit. these have saved my butt several times. If it aint square, I don't care. 84 C35 ...