P0335 Diagnostics Pinpoint the Root Cause with Expert Analysis

The crankshaft sensor is located passenger side just above oil pan gasket in front of transmission housing just a caution they do get stuck and break off. I have a 2013X. I replaced the crankshaft sensor with a oem part and changed the wire harness, because the connector was corroded. I did the research and replaced the Crankshaft Position sensor. It started up and cleared the error on it's own; CEL was still on so plugged back in the code ... The crankshaft sensor is bad vs wiring harness issue. Plan: Remove crankshaft sensor and use a digital multimeter to check the resistance. This P0335 code pops up, I noticed it says “circuit” is the wire itself that connects to the sensor or do I need another sensor. 2000 320ci, having fun on dirt, car stalls + limp mode + code P0335. Came out of limp mode after 5 mins, drives normally. Tested crank sensor, voltages were ... The crankshaft position sensor is the primary part for P0335, but the camshaft position sensor is the secondary part for P0335. Sometimes the ... P0335 is a CIRCUIT error, not a timing error. The crankshaft position sensor circuits consist of an engine control module (ECM) supplied 5V reference circuit. DTC72 ... My 2006 LC100 threw the P0335 code right before I was headed to Silverton, CO to run some trails. I found this thread and with almost no ... This fault code means NO CKP sensor signal for 2 seconds at engine cranking. So it is only checked on initial cranking which explains why it can ...