P0335 Decoded A Comprehensive Guide to Crankshaft Sensor Error Code Diagnosis

The crack position sensor is located behind the intake manifold right by the fire wall. You are going to need a mirror to get it out if thats ... The procedure in AllDataDIY looks pretty straightforward {unplug harness, remove two screws, R&R sensor, etc} but the standard time for the job is 2 hours. Three things. First, make sure the sensor has a solid 12V between the RED and BLK wires. If not, that power circuit runs from the ECM reference ... This is what causes the P0335 Code: No CKP sensor signal to ECM while cranking (1 trip detection logic), No CKP sensor signal to ECM at engine speed of 600 rpm ... The code started after replacing the Cam position sensor (as you post seems to suggest), I would first suspect a bad sensor. Switch out with the old one. I've been looking for the sensor. This is for the V6. I think one end is under the engine cover and the other is where the transmission meets the engine on the ... A code P0335 could mean one or more of the following has happened: a wire or connector in the circuit could be grounded/shorted/broken, the camshaft position ... DTC72 ... My 2006 LC100 threw the P0335 code right before I was headed to Silverton, CO to run some trails. I found this thread and with almost no ... P0335 error code-changed crankshaft sensor- now im thinking electrical ... I replaced my crankshaft position sensor and the error code went away. I have a 2013X. I replaced the crankshaft sensor with a oem part and changed the wire harness, because the connector was corroded.