Key Resists Ignition's Release Harnessing the Power of Knowledge

And yes, if the battery dies in the Cruze, the key will not come out of the ignition. The ignition release for the car being in park is ... If you refer to your owners manual it mentions this problem may occur if there is some kind of malfunction, but does not say anything about how ... Usually this is caused by failing ignition lock cylinder, listen for key in ignition chime with key removed, try tapping on cylinder and see if chime stops. If ... The key release is a solenoid activated by a switch in the shifter. Either the switch is going bad or there is lint or dirt in the shifter gate preventing it ... Use your left index finger to push down on your key cylinder. At the same time, jiggle your key with your right hand. This can loosen springs ... In the immediate term though when your key gets stuck, simply turn the ignition power back on and squeeze the button and quickly release it. You can try this out on a working lock: Turn off the ignition, leave the key in, put tension on the steering wheel then try removing the key, it ... Just a quick spray of WD-40 takes care of it. In fact you can squirt the stuff in there without taking apart the mechanism. It could also be a clue that OP somehow got the wrong key and jammed it in there. Lacking the proper transponder chip, the car won't start with ... There is a little tab on the ring surrounding where the key goes in - pop it off to reveal a little hole. Stick a paper clip in it and release ...