Transform Your Skills with p0123 The Complete Training Guide

The problem is the code only comes back after i accelerate through a right turn so i dont see how replacing the tb would fix said issue. It sounds like the spot check is OK, Try wiggling and moving the wires. The computer only has to see the high voltage for .5 seconds to set the code. P0123 limp mode · Malfunctioning throttle position sensor · Bad pedal position sensor · Sensor circuit issues, including loose connections, ... The TPS sensor should produce around .5v at full closed throttle plate and around 4.5v with the pedal all the way down. Inspect the butterfly valve on the throttle body. If it is dirty, then clean with a soft cloth and some isopropyl alcohol. Verify that it has ... I got the code P0123 so I figured I'd check the Tps sensor voltage and it was reading fine (has power, signal, ground) also checked it with throttle open and ... The general OBD-II code P0123 indicates that the TPS circuit A output voltage has exceeded the sensor's intended voltage specification range, as ... VRSC Models - Help, Code P0123 - Bike is dying on me, ran the diagnostic & cleared code P0123, but still not running right! P0123 (M) Throttle Position Sensor Voltage High Throttle position sensor input above the maximum acceptable voltage. Been getting "P0123 - Throttle Position (TP) Sensor Circuit High Input" lately during WOT. CEL comes on but resets when car shuts down.