Master the Secrets of p0123 The Comprehensive Guide

Comments Section ... Check your throttle body? ... Did you maybe unplugthe throttle body or is the harness/connector broken? Both DTC' point to a ... The quick and dirty way to make that code go away is to leave the key off and pump the gas pedal all the way up or down 50 times to clean the ... No jumps in values in either direction. Normally that code means a defective part is detected, but best to test it before your replace it. You ... Known causes of this issue can be the accelerator pedal assembly, the TPS sensor at the throttle body (or somewhere near the brake master cylinder), a worn ... Inspect the butterfly valve on the throttle body. If it is dirty, then clean with a soft cloth and some isopropyl alcohol. Verify that it has ... The reference voltage should be 5V. The reading at idle should be .6V. The WOT reading should be above 4.0V, but when it goes above 4.75V, the DTC gets set. Code P0123 TPS sensor ... Have you tried disconnecting the TPS sensor connector and checking to see if it's clean and tight? It's a quick start ... This was the first time I have ever seen 12v on a potentiometer style throttle position sensor. The spec for this sensor is around .5v at ... A P0123 code means that the car's computer has detected that the TPS (throttle position sensor) is reporting too high a voltage. P0123 Throttle Pedal Position Sensor/Switch (TPS) A Circuit High Input symptoms causes solutions #P0123 #tpsensor #causes #sensor ...