Masterclass Rear Passenger Bearing Hub Replacement for 2012 Vehicles

... passenger rear side of the car. I have also had pre-mature wearing on the inside of the rear tire that has caused the early replacement of the tires on that ... It needs a rear wheel hub assembly. I have it all torn apart. But when looking at replacement bearings i have seen 3 bolt ones and 4 bolt ones. Well I was able to finally change the Passenger Rear bearing before the holidays. I was correct, the inside bearing on the hub assembly was shot. Replaced ... This video shows you how to replace a rear hub assembly on your 2008-2012 Chevy Malibu. found a write up for removing front bearings, knuckles have to come off. So for rear with AWD I'm assuming the same. Passenger side saturday, ... 2325 posts · Joined 2012 ... So I have some fluids being sprayed into the inner side of the rear driver rim and I'm suspecting it's a bad axel ... I didn't think that was worth it. You need to press the old part out and press it into the new hub assembly. Don't try to use a hammer to ... ... repair was done on a 2011 Honda Odyssey and the process should be similar on the following vehicles: 2011 Honda Odyssey 2012 Honda Odyssey ... There's absolutely nothing special about wheel bearings/hubs. In fact, it may be easier and cheaper to replace the entire hub with the bearings. Do not forget to add the new snap ring before pushing the hub back in place. Pushing the hub in will require 5-6t. Pressure must to go only on ...