Elevate Your Ride Replace Your 2012 Vehicle's Rear Passenger Bearing Hub Like a Pro

Notice: Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become ... Rear wheel bearing/hub replacement DIY guide · 1. Jack up car and remove wheel. · 2. Press or pry out the pads or caliper cylinder from disk for ... Buy AutoShack Rear Wheel Hub Bearing Pair of 2 Driver and Passenger Side Replacement for 2004-2012 2013 Mazda 3 2009-2013 Mazda 3 Sport 2006-2010 2012-2017 ... I can hear noise related to bearings from passenger side. But I cannot tell if it is front or rear. But my daughter's ears are better and she ... Beat the **** out of the hub and flange,; Put the four hub assembly bolts in the opposite direction and tap them from the back,; Mild heat (I ... Use slide hammer with hub attachment to remove the hub. This took at least 20-30 hard raps. Fortunately I am not in the snow/rust belt, so YMMV. Well I was able to finally change the Passenger Rear bearing before the holidays. I was correct, the inside bearing on the hub assembly was shot. Replaced ... 2325 posts · Joined 2012 ... So I have some fluids being sprayed into the inner side of the rear driver rim and I'm suspecting it's a bad axel ... Backstory: Both my front wheel bearings were toast at roughly 140,000km, with the passenger side noticeably worse (REALLY LOUD). It had started ... I just had a wheel bearing that went out in the rear and VW wants $285 for just the one wheel bearing/hub assembly. I have done a fair amount of ...