Steering Couplers Your Guide to Enhanced Control and Stability

The problem is that it doesn't look like the steering column shaft is in the flange far enough to really hold it. The green line on my pic is where the shaft ... I substituted a VW disk for the C coupler in my 1963 SC years ago an found the steering wheel "feel" to be fine. Top. User avatar. Martin Benade ... New reproduction of the rubber steering puck and bolt tubes. This part acts as a vibration dampener, flexing to offer a smoother steering response when ... Steering Couplers ... A NEW Steering Coupler is an essential update to your GM or Jeep project to eliminate undesirable "steering slop". Don't see what you need ... With BAC No Cut Steering Box Coupler there's no need to modify steering columns on A, B & E body vehicles when installing Borgeson/Delphi power steering ... The rag joint (3A525) is a separate part, it bolts to the flange of the Lower Steering Shaft & Coupler Assy (3B676). Rag joint then attaches to ... Sold on Exchanged Only | Steering coupler hardware only for your Datsun 240z. The rubber coupler is not included. The core must be received before parts are ... It is either remove the upper part of the steering column, or remove the steering box from the frame, along with disconnecting it from the steering linkage. You need to drive out the pin with a punch then the coupler body will come off the shaft by tapping with a hammer. Couplers are available for direct steering connections where an angle is not required. Couplers can also be used to extend the steering shaft.