Engine Size Enigma Solved by the Engine Block Number

Engines built at the Tonawanda engine plant have the engine identification number located at the right front top of the engine block. - The ... The casting number on the LS2 is located on the driver's side, in the rear, just below the deck surface. It's darn near impossible to get a photo of it in the ... You will often find the engine number on the engine block or distributor cap. It is not uncommon for the identification plate to be obscured by dirt. If this is ... The 6-cylinder engine numbers are stamped on a pad located on the right hand side of the engine at the rear of the distributor. 4.3 Liter Engine, (VIN Code Z) ... Here is a close up of the casting number. You can see that the engine size is cast into the block at the end of the casting number. This is ... That's definitely your serial # sticker (#10537). Is it located at the right front side of the engine block? That's the only location that the factory service ... If the engine is orginial to the truck; your vin number will enable you to determine the engine size, on the side of the block near / above the ... The number you found would be for the intake manifold itself. To id the engine block, check the front face of the block, near the distributor on the driver ... The bore size of GEN-1 engines is cast into the left rear of the block. This is covered by the bell housing when engine is in a vehicle with ... All Honda engine serial numbers have a 4 or 5 letter prefix followed by a 7 digit number. Small Engines Models ...