Master the Art of Timing Cover Replacement A Step-by-Step Manual

The Upper Oil-Pan should be adjusted/aligned to the rear engine cover, otherwise it might lead to some strange reverb sounds. The pan will need to be dropped. Good thing is that the pan gasket is the re-usable kind, so drop it down a little and put it back up when done. You must log in or register to reply here. Similar threads. C. Remove radiator to gain better access. Remove starter dog and crankshaft pulley. Remove bolts holding timing chain cover in place. NB the bolts are different ... Before you can remove the timing cover, you need to take off the main pulley. This requires a larger 35mm socket. This nut will be on very ... There are 2 bolts on the bottom that go up thru the oil pan, did you get them out? Mine just came right off, didn't need to pry at all. Loosen the front 2 pan gasket bolts and with some finagling and a bit of prying at the right spots, you can get those triangles to slip into place with some ... The only thing I know about is replacing your stock cover with a two or three piece cover. The oil pan gaskets can be a pain to seal as it is. Im trying to get the timing cover out I have the alternator out and the belt and the tensioner pulley. there were 4 long screws that when i took out a lot of ... A plastic cover coming from the front valance that goes back up almost to the suspension area. About 5, 10mm bolts and you are wide open to everything.