Engine Rejuvenation A Step-by-Step Guide to Replace Your Camshaft Sensor

How To Replace a Faulty Camshaft Position Sensor Is your check engine light on? Experiencing poor engine performance or misfiring? It really is a hard harness to get out of the way. The only "easy" way is to lift the harness and "crack" the back of the plastic. This will ... If you have replaced the cam sensor and the truck will not start, you may have a bad crankshaft sensor, if you have a volt meter, you can back probe the ... Disconnect the Camshaft Position (CMP) sensor electrical connector. Remove the bolt and the CMP sensor. LH exhaust Camshaft Position (CMP) sensor Position the ... That way you can install the camshaft sensor on the bench instead of squirming around in that tight space with the crank pulley and water pump ... I got it, got the engine hot and sprayed some WD-40 between the sensor and engine and kept wiggling to get it lubed up, then grabbed some pliers ... FIRST, you should disconnect the battery (I never do that, but since the stupid sensor was so expensive, I did it as a precaution). Remove the ... The camshaft "sensor" (AKA actuators or solenoids) are located on top of the cam cover at the front of the engine. Left is intake, right is exhaust. Said it was a camshaft position sensor. I searched on here and found that it's under the distributor. Where at exactly and how do I replace it? The cam sensor is behind the p/s reservior on the drivers side.Take the reservior bolts loose and move it aside,then remove the cam sensor bolt and pull it out.