DIY Success Step-by-Step Guide to Replace Your Camshaft Sensor

Parts needed: · Remove the Vanos solenoid with a 32mm wrench, and a 15mm for the Vanos oil line. · Use a 5mm hex to remove the sensor from the ... The camshaft sensor can be a bit tough to remove. Best bet is use a "twist-and-pull" method. Keep twisting back and forth while pulling, and you should be fine. It is on the back of timing cover near back of VP and is accessed with a 12" + extension and Allen head socket. 1. Let the engine cool down. You will most likely end up touching the engine or the catalytic converter while doing this. Obviously both get hot, proceed with ... Here in the USA, the sensors are about USD 130.00 from the dealer. If you are going to try this job yourself, you also will need a new big green ... There are two camshaft position sensors on the H3 - Intake and Exhaust. I replaced both of mine after getting a couple of codes a few times ... Find certified shops for Camshaft Position Sensor Replacement near you with a 12000-mile/12-month warranty. Get expert advice and cost estimates on ... Remove crankshaft sensor - The crankshaft sensor is also held on with 2 10mm bolts and is right there above the crank snout (note: it slides ... Best Prices for Camshaft Position Sensor Replacement. Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing. Depends on the make and model of the engine, remove the wiring from the sensor then remove the hold down bolt , remove the sensor, put a little ...