TPS Reset 101 Expert Tips for Improved Engine Performance

Cure; turn off engine, key to position 2, fully depress and release throttle pedal 5 times, turn off key, start engine. Result; idles as it ... Just had to do the reset. No issues with it. You turn the ignition on, wait 10 seconds. Then turn the ignition off, wait 10 seconds. Do this 4 ... To zero the TPS: 1. Set the Run/Stop switch to the Run position. 2. Turn the ignition key to the On position. 3. With the engine off, rotate the throttle grip. TPS reset routine: 1) Disconnect battery for about 30 seconds then reconnect (causes ECU to lose it's memory of Throttle Position Sensor). 2) Turn ignition to ... :confused: MOGolf said: Key on with engine off. Push go pedal to the floor for at least 5 seconds. Release pedal. Turn key off. ... Do I get any kind of light or ... My PCV reads the TPS in it's actual sensor voltage... not sure how PCIII reads it. ~2009 Roadstar Warrior Midnight~ - VBak Intake - AIS Block ... ... Position Calibration, Modulate Throttle Cycling A/C Clutch Relay ... NOx Sensor Reset; 22. ODO Meter; 23. Oil Maintenance Reset; 24. Rainfall Light ... Step 3: Depress the accelerator REALLY slowly...Driving Miss Daisy with a touch of Cocoon slowly...all the way to the floor. Step 4: Release the ... On some vehicles there is an actual procedure like turn the key forward, hold the gas pedal at WOT, turn the key all the way forward w/o starting while pulling ... Perform “Throttle Valve Closed Position Learning”. 3. Start engine and warm it up to normal operating temperature. 4. Turn ignition switch “OFF” ...