DIY Throttle Position Sensor Reset Empowering You to Enhance Engine Performance

The Foxwell NT809TS OBD2 scanner is a great tool for resetting the TPS. Not only does it support a TPS reset, but it also offers over 30 additional reset ... My PCV reads the TPS in it's actual sensor voltage... not sure how PCIII reads it. ~2009 Roadstar Warrior Midnight~ - VBak Intake - AIS Block ... On some vehicles there is an actual procedure like turn the key forward, hold the gas pedal at WOT, turn the key all the way forward w/o starting while pulling ... The mechanic will turn the car off and disconnect the negative battery terminal. They'll wait 5 to 10 minutes. This allows the engine control unit (ECU) to ... To reset the throttle control on Your 2004 Ford F-150 turn the key to the on position(engine off). Then slowly depress the gas pedal all the ... To zero the TPS: 1. Set the Run/Stop switch to the Run position. 2. Turn the ignition key to the On position. 3. With the engine off, rotate the throttle grip. :confused: MOGolf said: Key on with engine off. Push go pedal to the floor for at least 5 seconds. Release pedal. Turn key off. ... Do I get any kind of light or ... Turn ignition switch “OFF” and wait at least 10 seconds. 5. Conform that accelerator pedal is fully released, turn ignition switch “ON” and wait 3 seconds. 6. The global position, as returned by the Global Positioning System (GPS). This is. NOT the global position estimate of the system, but rather a RAW sensor value. Start the Engine and Let It Idle · Run the Engine for 3 Minutes, Shut It Off, and Run It for 3 Minutes Again · Turn the Key On, Let the Engine ...