Conquer the P2004 Code Challenge A Comprehensive Toolkit

I'd check all vacuum lines and at the very least, clean or replace the EGR valve before removing the intake manifold. I followed the manual and found the vacuum switch. It's towards the rear of the Intake Manifold. I kinda 'bopped" with a plastic hammer to see if I could shake ... P2004 Intake Manifold Runner Control (IMRC) Stuck Open (Bank 1) This DTC is set when the IMRC is commanded closed, but the IMRC monitor indicates open. DTC codes P2006 / P2004 Relate to the Intake Manifold Runner Control Stuck in the open and closed position. You say you can hear the solenoids ... Member ... So I've found out that if I pump my brakes while standing still for about 20 seconds, the check engine light will always come on. The ... Hi My check engine light popped with P2004/P2017 codes. I drove to service station and they told me intake manifold engine is dead. P2004 code ... Did you take the intake off to clean the TGV? Each side has an actuator and a position sensor. If there's a lot of sludge built up ... P2004 is a stuck Intake Runner (Tumble Valve), the ECM is getting a mismatch between the actuator command and the angle indicated by the sensor. How to replace an intake manifold runner solenoid on a 2004-2009 mazda 3 or 6. This is for the models that have 2 separate IMRS parts. Code; Inline code. Alignment. Align left; Align center; Align right; Align Justify. List. Ordered list; Unordered list; Indent; Outdent. Insert ...