Protect Your Valuables The Importance of 40 Amp Fuses

A 32 volt fuse will be just fine. Just an operating spec for the fuse, you can always go up in voltage rating with no issue, so somebody found ... The 40 Amp fuse was blown then I noticed the insulation on the wire had been rubbing the frame and had a very small spot that was causing it to ground out. This fuse is one of two big orange ones located in the rear trunk on the left side. They are just in front of the relay box. The Best Quality Fuses And Fuse Holders Designed To Fit the Cable Required For The Specified Current And Make A Solid Connection Limited 2 Year Warranty. The fuse under the seat for the Electronic Power Steering melted. Has anyone experienced this before and what would cause it to do so? I wondered if it might be more prudent to go with 40 amp bolt-down type fuse such as Baomain ANL 40 amp in a Baomain holder, or a Little fuse 40 amp Mega or...? The normally reported cause of the 40 amp converter/charger output fuses being blown is a reverse hookup of the battery or charger cables. The 40 amp fuse is a heavy duty slow blow. It is in series directly with the #30 pole on the ignition switch and heavy gauge wire terminating at the battery ... I removed the 40 amp fuse for the engine and now the vehicle will not start. I am unable to check out the engine. Please. The wire connected to the green fuse on my Jeep goes down behind the battery. That's all that I can see of it.