Expert Insights Resolving EGR Monitor Issues with Confidence

OBDII checks misfire, fuel trim and purge again. 6. Hold at a steady speed of 55 to 60 mph for five minutes. OBDII monitors catalytic converter ... Quote: From a stop, accelerate to 72 Km/h (45 MPH) at 1/2 to 3/4 throttle. Repeat 3 times. Executes the EGR Monitor. This might be something you need dealership help for. As stated, disconnecting the battery is usually working against you, so clear codes with a ... Is there as specific drive cycle procedure for the CJAA engine? Is there some issue because of dieselgate reset of computer or replacement of ... Disconnecting the battery will start the emissions readiness cycle again, so does clearing codes. If you do not have a few days remaining before ... You need to drive several days over a wide range of speeds, etc. It's not just about the miles driven. Also, if the computer sees a problem in ... So basically get up to 55 mph, hold it for 10 seconds, let off the gas for 5 seconds and let it coast down. Go back to 55 for 10 seconds and ... Told me "Catalyst & EVAP" not ready. They told me to drive and follow the drive cycle. I did 5-6 times. Still not ready. Reset the ECU using ... I rarely need more than 10 miles to set all monitors. It is either the way you are driving it or you have a problem. Just look up the parameters that need to be ... I'm not sure if it's an electrical issue or if there is something else I can clean out/replace that would help get the EGR monitor ready.