Fuel System Monitor's Secrets Unmasked Resolving Readiness Issues

the OBD system has not yet completed ... 1996-1998 Mitsubishi vehicles - These vehicles may have a high degree of “not ready” for the catalyst monitor. I read a response on a non tech site regarding saturn drive cycles that you must also cold start with the fuel level between 15 to 85 %, and do ... ... my monitors to enable except for the fuel monitor. I ... #5. So i found some good info on why the fuel system monitor might not be ready Right. I have been to a few of these rodeos. Usually fuel monitor is the first to complete, then the cat and O2 are usually taking their time. Is Your Evap system not ready? Want to pass the emission test successfully? Learn about the importance of the Evap screen and how to ensure ... BUT i went to complete a drive cycle after the codes were cleared and i checked after 100 miles and the evap and fuel system are not ready. this ... This condition can be achieved by letting the car to sit overnight. The ignition key must not be left ON position before the cold start. Did you change batteries or disconnect the battery? (main cause of issue). Because if you did it takes a long time to set this monitor to ready. The fuel system monitor fails to get ready anyone have any input on this. I have did drive cycles and replaced thermostat and O2 sensor. There is no check ... Issue #1: -After doing the driving sequence for 3 times, everything was ready, but FUE (Fuel System) monitor was not ready. ... Issue #2: - ...