Fuel System Monitor's Readiness Woes A Step-by-Step Guide to Resolution

Issue #1: -After doing the driving sequence for 3 times, everything was ready, but FUE (Fuel System) monitor was not ready. ... Issue #2: - ... So even after two weeks and 550 miles, the catalyst monitor is still not set. I ... Evaporative system monitoring: Not installed. Secondary air system ... The number of incomplete OBD readiness monitors that are allowed to pass the OBD test portion of a Smog Check inspection are provided below. Model Year, Fuel ... The fuel system monitor fails to get ready anyone have any input on this. I have did drive cycles and replaced thermostat and O2 sensor. There is no check ... You have to do a couple "drive cycles" to get all the monitors to read "ready". ... 20 minutes of stop-and-go driving with at least four 30-second ... I recently had an issue where I had a clear a DTC code from a loose wire on the turbo vane before I could smog my truck because all codes ... What component of the EVAP system is not ready? ... During this step the OBDII system checks for ignition misfire, fuel trim and EVAP canister ... Have you tried finding and following the procedure for clearing all the monitors? If this is for emissions testing many jurisdictions allow one, ... Reconnect in the reverse ( red then black) after 20 minutes. Attach your obd 2 scanner and initially almost all monitors are incomplete. What I ... I havent put a lot of miles on it since but my only monitors having a hard time setting are 02 sensor. The heater is good. Fuel system will ...