Decoding the Fuel System Monitor's Silence Unlocking Readiness

The fuel level being empty, and now full, may have a lot to do with your troubles. Once it gets down to around 3/4 tank, I'd start watching the ... Looks like it's just your evaps. Some of those you don't have and a better scanner would say not supported or something. So that is the one test ... So even after two weeks and 550 miles, the catalyst monitor is still not set. I ... Evaporative system monitoring: Not installed. Secondary air system ... My jeep failed NJ inspections (emissions) for “Fuel System Not Ready”. After completing 2 drive cycles it was still reading not ready on my pocketscan. not set on certain flex fuel models. Readiness monitors are disabled for operation if greater than >E10 blends. The monitor will ignore all 11 ... I havent put a lot of miles on it since but my only monitors having a hard time setting are 02 sensor. The heater is good. Fuel system will ... When mclarensf hooked it up to their computers the error message was basically interpreted to be "bad fuel". That's what they thought it was originally until ... have the fuel tank between 30 and 70 percent full. some systems, especially the evap system, need to have a specific level of fuel in order for ... Had to get a smog check last month and tech informed I had several monitors in a not ready state. I attempted the BMW drive cycle but haven't ... chances are the ecu just did not have enough time to cycle and set the readiness codes. give it more time and try again.