OBD II Pin Configuration Simplified A Step-by-Step Guide for Beginners

The factory plug has all 16 pins. The plug is molded with no way of knowing which pins the red and black wires are connected to. Hello. Been having a heck of a time getting readings out of OBDII port. Replaced all the pins, still getting the same issue, so I'm assuming one ... Everything Electrical & Electronic - Accidental short across pin 4 and pin 16 on OBD II plug - I'm not sure all the damage this has caused ... The info I posted earlier shows the CAN BUS pins are pin 6(high) and pin 14 (low). The ISO-9141 data lines are 7 and 15. Your plug may be ... Just a black & red wire sounds like a ground & power connection. If the black wire was plugged into OBD2 port pin #4 or #5, and the red wire was plugged into ... OBDII pinouts are key to understanding the data flowing through the vehicle's OBD connector. There are two types: standard pins for basic ... BMW had the 20 pin round connector up to 2000. At that time, the changeover to the standard OBD2 connector was mandated. My 98 328iC has both. The DLC or Data Link Connector is an OBD II, 16-pin, standard connector used in all automobiles manufactured since 1996. The ECM's electronic control modules ... If their OBD-II power adapter truly only uses pins 4/5 ground and pin 16 for power, there must be some sort of voltage level detection going on ... OBD-II adapter for Hino vehicles with type A plug and 9-pin receptacle. Use in conjunction with one of the following cables: Standard 9-Pin Y-Cable for TND ...