Mastering Brake Control Preventing Lockups in All Conditions

if the distance between them is even slightly off the sensor tells computer that the wheel is locking up. If it is rusted where the sensor is ... If you push down hard enough on the pedal it should be able to lock up the brakes. You should try and confirm this. If not then something is wrong. This sounds like a master cylinder issue. Previous experience I had a buick do the same thing. Locked up then released. This is very dangerous. Brakes locking-up when stopping can be caused by a brake system mechanical problem, or the result of driving/road conditions. The problem was the high pressure from the master cylinder was enough to force past the blockage but then wouldnt work it way back out. Pull ... During testing in a safe area, I found that the brakes will release after some time delay if the car is traveling at moderate speed (perhaps 40 ... I pressed the brakes and they locked up on me. They got really stiff ... The 53% oil life has to do with driving characteristics ... When you replaced the master cylinder did you adjust the push rod length? It's very important that the length of the new rod is adjusted ... It could be the engine/powertrain control module was shaken over the bump and was damaged, causing it to stall the car, then to run very rough. If yes, then your fluid was contaminated and every rubber part in the system need replacing. All hoses, all calipers, ABS module, and your new ...