Wiper Fluid Conundrum Identifying and Fixing the Culprit

I'd check for blockage and make sure the tube/hose from the pump or reservoir is connected and intact, check the pump isn't sucking air from the reservoir ... The reservoir was topped off. I only use summer type window cleaner solution. I can hear the pump whirring when I try to spray solution but nothing comes out. You can try unclogging the nozzles yourself using a fine needle or pin. Simply poke it into the nozzle, and gently jiggle it around a bit. Then test them again. I also use my washer fluid nearly everyday which is why I was surprised how fast it clogged up. Today I siphoned out the fluid and filled up ... Theories #2 & #3 are the motor is bad and caused the overload or possibly the wire between the relay and motor is shorting to ground. Sometimes it's as simple as clogged nozzles. I've had that happen often in the past (especially if you run your system dry on accident when ... Also make sure the sprayer are not clogged. A pin will unclog any blockage. Also if freezing dump a pint of hot water on the sprayer and brush ... If you hear your pump humming but you don't see any fluid coming out from the nozzles, the fluid tank may be empty or there may be a clog. The tubes that are ... Could be frozen, could be the pump has packed in, or maybe the fuse has gone. Check the fuse first, if that's ok add some warm water to the ... One key here is to make sure you push the button in to the second click. If you push the button in one click, you just get a wipe.