Transform Your BMW's Performance Fuel Injector Open Repair Mastery

If you have fuel pressure and can hear the click then pull the injectors and clean them. If there is no click then there is a good chance they ... 3) Details on when the diagnostic runs and the conditions for setting the trouble code if a fault is detected that reduces current flow or the voltage spike ... If wire from EMM to injector passes tests and close inspection, then switch #1 injector with its neighbor. and see if miss follows injector. take the injector connector off and look into where the pins go. make that gap in the terminals smaller with a pick from the front. They're basically spade ... To remove an injector, you have to disconnect the electrical connectors to all the injectors. Then remove the fuel rail with all injectors attached to it. The Noid light should blink crisply when the engine is started or cranked over. If the Noid light does not blink, I check the Fuel Injector harness for ... The rail just pulls straight up, after you remove the two (from memory) bolts holding down the fuel rail to the top of the injectors. the only ... The same Bosch Diesel network also offers locations that can test and repair your injectors. These locations are denoted as Bosch Diesel Centers. By testing the ... If the injector is open all the time, then it's toast.. The Injector is hooked to the 12 volt line.. the ECU is the device that will pull the ... Next, loosen the fuel lines from the injectors with a 14mm wrench. Have even more rags ready for the fuel that will come out of the lines. DIY ...